Miracle Box 2.40 Setup - Volcano Box v3.0.9 SetupZ3x Samsung Tool PRO 27.1HWK+UFSx Box Update v2.3.0.7

Samsung GT-I8190 Charging Solution Problem Jumper

Samsung GT-I8190 Charging Jumper Ways
Samsung I8190 Not Charging Problem SolutionCharging problem in Samsung galaxy S3 Mini GT-I8190 is really not a common one, but when it happens you really know that you are going to have a very bad time! Charging problem can occur due to any of the reasons, it could either be due to water damage or physical damage.

In the following lines you will get to know simple and effective troubleshooting methods to overcome Samsung GT-I8190 Charging problems.

Problems
Phone no Charging.
Auto Charging.
Showing “PC connection” error message.
Phone heats up during charging.

Manual Solution
Check with any other original Samsung charger.
Clean Charging connectors and check

Tools Required
Following are the tools you need before you plan to go with hardware method
Soldering Gun.
Heat Gun.
Multi meter.
Plastic separation tool.
Plus screw driver.
Jumper Wire (Copper wire).

Samsung S3 Mini GT-I8190 Charging Hardware Solution

samsung gt-i8190 charging jumper problem solution

OR

Samsung GT-I8190 Charge Connecter Ways Solution

Check, clean or replace the charging pin connector (DC jack). clean also the PCB pads.
Check/replace the Charging connector.
Check the charging voltage (VCHARGE).
Check the below image for Charging Ways.
If any Track ways is missing just apply jumper.
Samsung GT-I8190 Charging Ways Solution

Note: Please note that even though every solution posted on our website is tested by one or more members of our team before posting, but still we do not take any responsibility for any damage it may cause to your cell phones. Use these repairing solutions at your own risk. Thank You.

Samsung GT-I8190 Charging Ways Not Charging Solution, Samsung I8190 Charging Jumper Solution Repairing.

One thought on “Samsung GT-I8190 Charging Solution Problem Jumper”

  1. arent there at least two more contacts missing -> usb- and usb+

    and supposed a third one:
    otg-sense to switch direction of usb-data-transfer…

    i could nowhere find these lines depicted!!

    -have to check them:
    got a device with water-damage:
    not sure whether these additional signal-paths are still intact

Leave a Reply

Your email address will not be published. Required fields are marked *