Samsung Galaxy A10 A105G ISP Pinout – Dead Boot Repair FRP Remove
If you are Looking For The Samsung Galaxy A10 A105G EMMC ISP Test point Pinout Then You can check it on this Page. Here we Share Complete Guide to Repair Dead Samsung A105G using the UFI Dongle.
The Oppo F11 Run on Android 9.0 OS Which is Powered by Samsung Exynos 7 Octa 7884. it is a Dual SIM Smartphone that accepts 2 Regular SIM Card Including all other Connectivity Features Like Bluetooth hotspot & WIFI.
The Device Come with 2/3GB of RAM and 32GB of Storage Can Be Expandable via SD Card. in Camera Department, it Comes with 13MP Rear Camera With a 5MP Front Shooter.
Requirement:
UFI Box, Easy Jtag, AE Tool or any other EMMC tool and Basic EMMC Guide
Before removing or replacing IC eMMC you should do Direct eMMC first, still, discuss a little about and pinch, it turns out the partitions don’t match. for eMMC, use KMKJS, use the new boss, don’t use the 2nd one, what is 2nd, 2nd is the second boss of the former emmc who died or asks for TP because of the UFI BOX there support TP eMMC Samsung brand we can’t mention one by one because there are many from that by the eMMC owner the TP was revived and sold at a cheap price.
Steps to Bypass FRP on Samsung Galaxy A10 A105G:
Open back Cover of The Phone and Connect Wire With ISP Pinout As Show in below Image.
Install Require Driver on PC.
Now Connect Correct ISP Pinout to UFI box and Insert USB.
Now You can See Device in Device Manager
Run UFI Box Go to user Partition/ Special task and & Click Reset FRP.
Steps to Hard Reset Samsung Galaxy A10 A105G:
Open back Cover of The Phone and Connect Wire With ISP Pinout As Show in below Image
Install Require Driver on PC.
Now Connect Correct ISP Pinout to UFI box and Insert USB.
Now You can See Device in Device Manager
Run UFI Box Go to user Partition/ Special task and & Click Factory Reset
Done. that’s all.
Samsung Galaxy A10 A105G ISP Pinout – Dead Boot Repair FRP Remove
So that later when you want to direct again you are not confused looking for the Direct Pin, please boss just save it on HDD boss so that at any time there are cases that can be used again, congratulations, try the boss. one, please jumper for VCC VCCQ CLK CMD D0 GND for GND or ground don’t forget the jumpers are also bosses, otherwise, the jumpers don’t connect later.
Clear User Lock, you can try using ISP method via UFI eMMC ToolBox, use “Factory Reset” under Special Task in User Partition Tab. Or using AETOOL by MRTkey (Android Emmc Tool)
