Miracle Box 2.40 Setup - Volcano Box v3.0.9 SetupZ3x Samsung Tool PRO 27.1HWK+UFSx Box Update v2.3.0.7

Samsung Galaxy Tab 2 P5510 Short Power Problem Solution

Samsung Galaxy Tab 2 P5510 Short Solution Shortage Problem Repair

One of the biggest issues that anyone can encounter in his Samsung Galaxy Tab 2 P5510 phone is the power problem. This is mainly because if your phone is encountering power problems then definitely you cannot do anything in this case, as your phone won’t even power ON, hence forcing you to fix this thing at the earliest, else your phone would be of no use to you or for anyone else. Normally it happens that the power problem has something to do with your battery or battery terminals, and if the battery is the cause of this problem than you will surely be very lucky, as you only need to change the battery to overcome this problem, and you don’t need to go into the phone’s hardware components.

Problems
GT-P5510 not turning ON.
Powers off at Boot screen.
Heats up even when power is off and does not power on.

Reasons of Problems
Battery of Samsung Galaxy Tab 2 P5510 might be faulty.
Battery terminals of P5510 might be physically damaged.
Battery contacts might be rusted, hence causing power problem in phone.
Battery terminals could be water damaged.
Any other components of the phone are physically damaged or water damaged, hence causing any of those problems.

Hardware Solution:
Samsung Galaxy Tab 2 P5110 Short Problem Solution


Clean battery terminals if they are water damaged.
Re-solder battery terminals.
Check entire board for water damage, if some components are water damage then clean it and replace all the water damaged components if necessary.
Check phone button for any water or physical damage. To check power button all you have to do is to:
Check voltage at power button after placing both multi-meter nodes at power button points (It should be 2.8V).
After that, press power button to check continuity, at this point the voltage shown in multi meter is 0V, as Circuit is closed.
Then remove or change tentalum capacitor SMD.

Leave a Reply

Your email address will not be published. Required fields are marked *