Sony Ericsson ST18i Display Light Problem Jumper Solution

By Prateet Last updated Oct 7, 2014

Sony Ericsson ST18i Lcd Light Solution
Sony Ericsson ST18i Display Light Jumper
Sony Ericsson ST18i Light Problem Ways

In Sony Ericsson Xperia Ray ST18i light problem occur due to water damage or rust or carbon. so if you are facing light not working hang problem then look at the diagram given bellow it will help you to solve these problems.

Please Note that we will edit these solutions or add new ones if found in this page at any time in the future.
So feel free to come back any time on this page to stay up to date.

First See Your Phone Pcb For Some Rust Or Carbon Clean Whole Mother Board Of Your Phone With Any Good Cleaner For Water Damage.Apply Low Heat With Tour Hot Air Gun And Keep In Mind It Should Not Be To Much Because It Can Be Damage The Mother Board Of Your Phone.

Here Are The Solution Please Ovserve Carefully.

sony st18 xperia ray displaylight solution 11 300x194

2nd Solution

Sony Xperia ST18i Display And Display Light Ways
1. Try The Five-point Jumper To His Lcd Pin (see Picture Below)
If The Lcd Is Still As Before Rehot Or Replace Third Emi Filter Lcd

2. If Its Lcd Light Not Work After The Fifth Point Jumper Pin
Lcd ….. Replace The L7600 And V7601

sony st18 xperia ray displaylight solution21 300x153

If your lcd display is proper but only light is not working you should have focus on these two lines and check there path and parts.If you find any missins part or damage part then apply jumper there.

If you have further Questions please leave a comment.

Note: Please note that even though every solution posted on out website is tested by one or more members of our team before posting, but still we do not take any responsibility for any damage it may cause to your cell phones. Use these repairing solutions at your own risk. Thank You.

Sony Ericsson ST18i Display Light Problem Jumper Solution

Leave a Reply Cancel reply