LG P925 Power Button Ways On Off Key Jumper


LG P925 Power Button Ways Problem Repair Jumper Solution

For some reason the power switch terminal solder pads may also been severely damaged and lifted by the users., In order to fix this problem we need to bond the power switch to its original position so that it won’t easily break. But the problem is,  we cannot apply a solder on its terminal because the solder pads was already been lifted. To avoid hassle digging the PCB board you can refer to this solution below to locate which particular components where we can apply and mend a jumper wire to reconnect the said open line path of the power switch connection.

LG Thirill P925 Power ON-OFF Switch Jumper Solution
When it comes to hardware, the very first thing that you need to do is to re-solder power button strip and check its on-board connector for any loose contacts.
If the above method not working replace new power button strip.
Check power switch connection line paths accross to each components where it is being connected.
lg p925 power button ways

Locate the 10K resistor as shown on the solution above. the other side of that resistor is connected to the battery supply voltage and the other side is for the power switch line path

LG P925 Power Button Ways, On Off Key Jumper, Charging Ok but Phone Is Dead,On Off Key Ways Problem, Lg Thrill P925 Power Button Ways


Read More:-  Samsung Galaxy Fame Lite S6790 Power Key Jumper Solution
Leave A Reply

Your email address will not be published.