Samsung GT-S7262 Display Connecter Ways Light Solution


Samsung GT-S7262 Display Light Ways Problem Lcd Screen Jumper

Here’s a troubleshooting hints for Samsung Galaxy Star Pro S7262 LCD Display problem such as blank display or no display at all and otherwise a corrupted or garbled display. This solution may help you for easy repair procedures.

The quick step to fix display problem, is that you have to verify a working LCD, just replace the LCD screen module at once just to ensure that the LCD is working or not and then proceed to hardware troubleshooting after confirming that the LCD is still fine. Just locate the highlighted components shows on figure solution picture below and do have a careful check up on each one of them one by one.

For damaged or lifted display pin connector or due to wet or water damaged, here’s the tracing guide if you might think that the problem lies on a broken display signal line paths.

Samsung GT-S7262 display problem repair guide

Samsung GT S7262 Display Light ic Ways Lcd Jumper Solution
Samsung GT S7262 Display Light Solution Lcd Ways

Check the display pin connector, clean it, rework or re-solder it if necessary.
Trace also each connection line paths were it is being connected to a lighting section.
If any track line is missing just make a jumper.

If you have further Questions please leave a comment.
Note: Please note that even though every solution posted on our website is tested by one or more members of our team before posting, but still we do not take any responsibility for any damage it may cause to your cell phones. Use these repairing solutions at your own risk. Thank You.

Read More:-  Samsung Galaxy J6+ J610FN Charging Paused Problem Solution

Samsung Galaxy Star Pro S7262, Lcd Light Ways,Display Blank Or White Problem,Light Ic Solution,Display Connecter Ways,Display Light Jumper,Samsung GT-S7262 Display Problem Solution.

Leave A Reply

Your email address will not be published.