Nokia 150 RM-1190 Charging Ways Solution USB Jumper

Nokia 150 RM-1190 Charging Ways Solution USB Jumper
Nokia 150 Charging Solution Charging Ways Not Charging Problem USB Ways Fake Charging Problem Charging IC Solution

Here is the solution for Nokia 150 RM-1190 Not Charging problem like there is No Charging indication shows on the display when the battery charger is being a plug-in.
This problem is may cause by faulty components Nokia 150  PCB board. This problem may sometimes happen if the device suffered wet or water damaged or just exist

 

For those that own a Nokia 150, you may be having a problem that the Nokia 150 not charging correctly. Nokia 150 RM-1190  owners thought that the USB cable was an issue for the Nokia 150 RM-1190 not charging. So they went out and purchased a new charger, instead, some quick methods that we’re about to suggest can generally fix the problem when the Nokia 150  not charging when plugged in.

Below are the most common causes of why you Nokia 150 RM-1190 have trouble charging, and other problems concerning the battery like the grey battery issue:

  • Sunken sockets on the device, or bent/ broken connector
  • Factory-defective phone
  • Defective battery
  • Damaged charging unit or cable
  • Defective phone
  • Temporary battery issue

Hardware Solution:

Nokia 150 RM 1190 Charging Ways Solution USB Jumper 2

Check Charging connector for any kind of water damage, if it is then clean it and check.

Now re-solder charging connector pins and check.
Check charging voltage with the help of a multimeter. Place Negative terminal of the multimeter on ground and Positive on a charging pin (1st pin from your left-hand side).
Make sure that the voltage is between 5V to 5.5V, if it is not then replaced charging connector. (Charging Connector can be replaced by heating it from the opposite side of the board, while heating it, pull charging connector with the help of Tweezers).
Now remove metal sheet covering the charging section (It contains Charging IC and Components).
Check continuity between Fuse and Charging Pin (1st from your left-hand side). If there is no continuity, place jumper.
Also, check the following, and replace them if damaged:
Fuse
Capacitor
Coil
Heat charging IC, if it is faulty then replace it.
Now check charge at the battery terminals, if it is not standard voltage then re-solder or replace battery terminals.

READ MORE:-  Nokia 220 Mmc Ways Memory Card Not Working Problem

Nokia 150 RM-1190 Charging Jumper.USB Ways, Not Charging Problem, Samsung A320F Charging Solution, Samsung Nokia 150 Charging Ways

You might also like
1 Comment
  1. Robert says

    This is a perfect guide for those who are mobile technician like me and work for Nokia and other Smartphones. Thanks for the guide.

Leave A Reply

Your email address will not be published.

36 Shares
Share36
+1
Tweet
Pin