You can find the Realme C65 test points for booting the device into BROM mode here. The test point plays an extremely important role in mobile repair and software troubleshooting, especially when a device is unresponsive (dead), locked, or not detected by flashing software via a common USB connection on a computer.
A test point is a special hardware point on a smartphone’s motherboard. By shortening the test points, you can force the device into (brom) mode, allowing the repair tool to communicate with the phone at a deeper level. It is very useful for this:
What is the Realme C65 Test point?
Tool,Many Realme C65 5G devices face issues such as a dead boot, system corruption, or FRP lock. In such cases, neither normal download mode nor fastboot mode works. When the Realme C65 test point method becomes the only solution. With the help of the test point, you can force the device into brom mode and repair it using tools such as SP flash tool, Hydra tool, CMMTK2, Unlock Tool, or UMT. Without using the test point, these devices cannot detect the device when it is completely dead.
- Dead boot issues fixing
- Bypassing FRP lock
- Firmware flashing
- IMEI and security partitions
- Data recovery operation
Realme C65 Test Point Image:
The following image will guide you through shorting the pinout and successfully rebooting your Realme C65 to Emergency Download Force Brom Mode.
Required Tools for Repair
When the device is successfully put into MTK Preloader BROM mode via the test point, you will need a professional service software tool to perform the repair. Commonly used tools include:
- SP Flash Tool (Standard for MediaTek devices)
- Unlock Tool
- UMT (Ultimate Multi Tool)
- Hydra Tool
- CM2 (MTK2)
Guide to Use Realme C65 Test Point
- First, switch off the Realme C65 completely and remove the back cover.
- Disconnect the battery connector for safety.
- Find the Realme C65 test point on the motherboard (see the diagram above).
- Use a tweezer or a jumper wire to shorten the test point to ground.
- Connect the device to your PC using a USB cable.
- Open your Mobile Repair tool. and use the function you want.
- This process is not easy, so it is recommended that only experienced technicians attempt it. Running the test point incorrectly can cause permanent damage to the phone.
Frequently Asked Questions
The test point is a small spot on the phone’s motherboard. You connect it to the ground (metal shield) to put the phone into EDL or Brom Mode. This helps you fix software and lock problems.
The test point is a small spot on the phone’s motherboard. You connect it to the ground (metal shield) to put the phone into EDL or Brom Mode. This helps you fix software and lock problems.
Yes. You must carefully remove the back cover and the internal screws to reach the motherboard, where the test point is located.
It is safe if you are careful. However, opening your phone voids the warranty. Be very gentle so you don’t damage the small parts on the board.
If done correctly, your computer will show “MediaTek USB Port” or “Preloader” under Ports (COM & LPT).
