Nokia 610 Battery Connecter Ways Point Jumper Solution
Nokia Lumia 610 battery Low then Shutdown or restart set dead fault caused by either a faulty resistor and capacitor. Here we wants to share the experience how to repair this kind of damage.
Damage to the battery Nokia Lumia 610 could be in the causes for the phone does get wet, padded seat battery connector corroded and rusted breaking lines.
Here are tips on battery connector lines, check the track as in the picture below, if there is a path-breaking or not, if there is a path-breaking try doing jumpers carefully to avoid short-circuit condition of the phone.
Hardware Solution:
Diagnostics:
If Nokia Lumia 610 is not getting power ON, Replace the battery and try to power it ON. Plug in charging pin into jack and try to make it charge. Check batter terminal’s +v and -V points with electronics meter.
Solution:
Dis assemble the phone Nokia 610c and check battery connectors if these are lose or not fix. Then check the whole mother board for water and rust damages, Carbon or broken parts.
If find some rust or carbon make it clean with electronics cleaner and apply hot air with heat gun to make it dry.
Nokia 610c Dead Solution
Nokia Lumia 610 Battery Track Ways
Nokia 610 Battery Connector Jumper
Nokia Lumia 610c Terminal Jumper Ways.
