Nokia 108 Power On-Off Button Ways Switch Jumper


Nokia 108 Power On-Off Button Ways Switch Jumper
Nokia 108 Power Key Jumper On-Off Button Ways Solution

Here’s the jumper ways solution for Nokia 108 ON and OFF switch if the handset device showed charging indication when the battery charger is plug-in but unable to power up when the power button is being pressed.

Besides that, a problem in power button might also cause your phone to restart at times, which becomes very much annoying and it troubles you to the masses.

In the following lines you will get to know about Nokia 108 power button problems as well as their solutions:

Nokia 108 Problems
Nokia 108 power button becomes stiff.
Power button becomes unresponsive.

For Nokia 108 power button problem there is no work around method, however you can try using a pin and move it all around the Nokia 108 power button, as this might be able to take away some stiffness from your power button.

Nokia 108 Power Switch Hardware Solution
Here is the hardware solution for Nokia 108 power button problem:
Nokia 108 Power On Off Button Ways Switch Jumper

Repair hints for Power Switch problem on Nokia 108:
1. Check the power switch assembly, if the assembly is damaged replace the switch.
Sometimes even if the powerswitch is not not visually damaged, see to it that it still working by using a
2. For lifted button switch solder terminal pads on the PCB board, manage to re-establish the switch to its original position and bond it perfectly so that it won’t easily break. Then manage to reconnect the power switch line paths and the ground connection. If you can see an empty components solder pads just below of it,  you can connect it to that spot. that is also connected to the power switch.

Read More:-  Nokia Asha 300 Charging No Respons/Charging Not Supported Solution

Nokia 108 Power Button Ways, Nokia 108 On Off Key Jumper Solution, Set Is Dead Problem
Nokia 108,Power Button,Power Key,Power Switch,On Off Button, On-Off Switch, Power Problem

Leave A Reply

Your email address will not be published.