Samsung E1200 Network Problem Solution Signal Ways

Samsung E1200 Network Problem Solution Signal Ways
Samsung GT-E1200Y Network Problem Solution Jumper Ic Ways

Here’s the solution for a damaged Samsung E1200 with No Network Signal (coverage ) problem. This solution can be used if the problem is not caused by the device flash firmware. Try to restore or update the device flash firmware first before you may proceed to hardware troubleshooting.

This problem happens when the device suffered wet damaged or accidentally dropped.
For a water damaged Samsung E1200, you must ensure to clean the PCB board first before proceeding any software and hardware repair. And for accidentally dropped units like it shows a dropping signal indicator on the display, you may restore and or update the flash firmware first before you attempting hardware repair.

If the phone does not being fix through firmware restoration, you may then proceed to do a hardware check up and troubleshooting.
The solution below shows which particular components that may need to check, trace and or then replace if found damaged.

The RF circuit is composed of chips or integrated circuit (IC). In troubleshooting RF signal problem you may need to have a frequency counter to make it easy to repair, but you may also fix it by doing it manually.
First, check the all supply voltages that feeds to each of the RF circuit chips like the RF power amplifier and RF IC. There is an RF power supply controller that also feeds the secondary supply other than the battery supply voltage.

If you have further questions please don’t hesitate to leave a comment.
Note: Every repairing solution posted here is tested by at least one member of our team. Use the information available here at Your Own Risk. We are not responsible if any harm comes to your device during the repairing process.

Samsung E1200 PA Ic Jumper Solution, Signal Ways, Network Jumper, No Network Found Problem, Samsung GT-E1200 Weak Or Low Network Solution, Network Ways, Signal Problem.