Samsung Galaxy Tab 3 T111 Display Solution Lcd Light Jumper
Samsung Galaxy Tab 3 T111 Display problems in phones are surely considered to be one of the worst ones, and this is because a person has to do something on an immediate basis in order to overcome this problem, and the worst thing is that this is known to be one of the most expensive repairer solutions as compared to others.
Following are some of the Samsung SM-T111 display problems:
The blank display on.
Lines on the Display screen.
Abnormal Colors on display screen.
Reasons of Problems
LCD screen of Samsung Galaxy Tab 3 T111 has gone through some sort of physical damage (most of the time this is the case of Display problems in Samsung T111.
LCD screen of a phone or the phone itself might have encountered any kind of water damage.
The software is outdated.
Display connector might be loose, causing any of the above-mentioned problems in your phone’s screens.
LCD might be faulty itself, and you need to change that in order to overcome this issue.
On-board connector might be water damaged or faulty.
1. Turn On The Phone, Ensure That The Phone Has A Valid Sw If Not Flash A Valid Sw
2. Reheat Or Change His Fifth Emi Filter Or Jumper Lcd
See The Image Below:
Now Check Continuity between Display connector to the resistor compounds. if any of then is track missing then make a jumper.
If the above procedures don’t fix the problem the possible faulty is the main engine IC. Try to re-heat or rework it.
If you have further Questions please leave a comment.
Note: Please note that even though every solution posted on our website is tested by one or more members of our team before posting, but still we do not take any responsibility for any damage it may cause to your cell phones. Use these repairing solutions at your own risk. Thank You.
Samsung Galaxy Tab 3 T111 White Display Problem, Blank Screen, White Lcd Solution, No Light On Display, Display Connecter Ways, Samsung T111 Display Problem Solution, Jumper Way.