Nokia 1280,1616,1800 Final BSI Line Way Battery Jumper

Nokia 1280,1616,1800 Final BSI Line Way Battery Jumper
Nokia 1280,1616,1800 Battery Connector Ways Set Is Dead Problem Phone Not Powering On
Normally Nokia 1280,1616,1800 doesn’t have any problem, however, a good number of users have complained that they are encountering a battery percent always a problem in their new phone. We all know that Smartphone’s batteries aren’t that good, but battery drain and overheating is surely a problem.

In the following lines, we will discuss these problems in detail followed by the reasons that might be causing this problem along with the potential solutions.

Problems

Phone battery percentage always.
Nokia 1280,1616,1800 becomes extremely hot during usage.
Not charging problem charging level stuck.

Reasons of Problems

This happens when you use a third party charger to charge your phone. Use original Samsung charger.
Usage of the phone during charging might also be the cause of the problem.
Some heavy apps take a lot of charges and might also contribute in heating up your phone.
Usage of old firmware or the outdated OS also causes this problem.
A good number of apps are running in the background, causing the phone to lose charge over time, this also contributes in heating up your phone.
Outdated apps can also be the reason of this problem.
Your phone battery can also be faulty.

Hardware Solution

Nokia 128016161800 Final BSI Line Way Battery Jumper - Nokia 1280,1616,1800 Final BSI Line Way Battery Jumper

The very first thing that you need to do is to check battery voltage at its terminals in order to verify whether the problem is with the battery or with anything else. (Battery voltage should be at least 3.8V).
If the battery voltage is lower than 3.8V or is not showing charge then it means you need to change your battery in first place and check.

READ MORE:-  Nokia Lumia 1020 Insert Sim Card Repair Ways Solution

Now check battery connectors physically for any physical or water damage. In case it is water damage then clean the battery contacts. Besides that, also re-solder these battery contacts and make jumpers.

In case all of the above method doesn’t resolve your problem then check the entire board for any traces of water damage gently heat or re-solder if needed.

Nokia 1280,1616,1800 Battery Connector Ways, Bsi Line Jumper, Set Is Dead Problem, Power Problem Solution, Battery Connecter Jumper.

You might also like

Leave A Reply

Your email address will not be published.

108 Shares
Share108
+1
Tweet
Pin