Samsung Galaxy Fame S6810 Charging Problem Jumper Solution
Samsung S6810 Charging Ways Charging Solution Not Charging Problem Repair Solution
Here is the solution for Samsung Galaxy Fame S6810 Not Charging problem like there is No Charging indication shows on the display when the battery charger is being a plug-in.
This problem is may cause by faulty components Samsung GT-S6810 PCB board. This problem may sometimes happens if the device suffered wet or water damaged or just exist.
Before proceeding, ensure that the battery and the battery charger are in good working condition.
– Check all the components shown on the image below, you may start by checking the USB pin connector.
– Then the fuse, diode, capacitors and filter coil for possible open or short circuit.
– Trace each of the connection line paths from USB pins down to the components where it is directly connected.
Check Charging connector for any kind of water damage, if it is then clean it and check.
Now re-solder charging connector pins and check.
Check charging voltage with the help of a multi meter. Place Negative terminal of the multi meter on ground and Positive on a charging pin (1st pin from your left-hand side).
Make sure that the voltage is between 5V to 5.5V, if it is not then replaced charging connector. (Charging Connector can be replaced by heating it from the opposite side of the board, while heating it, pull charging connector with the help of Tweezers).
Now remove metal sheet covering the charging section (It contains Charging IC and Components).
Check continuity between Fuse and Charging Pin (1st from your left-hand side). If there is no continuity, place jumper.
Also, check the following, and replace them if damaged:
Heat charging IC, if it is faulty then replace it.
Now check charge at the battery terminals, if it is not standard voltage then re-solder or replace battery terminals.
Samsung Galaxy Fame S6810 Charging Jumper.USB Ways, Not Charging Problem, Nokia 230 Charging Solution, Samsung SM-G935F Charging Ways