Xiaomi Redmi 3 Charging Problem Solution USB Ways

Xiaomi Redmi 3 Charging Problem Solution USB Ways

Xiaomi Redmi 3 Charging Ways Not Charging Problem USB Ways Charging Solution
Xiaomi Redmi 3 Charging Ways Charging Jumper Here is the solution for Xiaomi Redmi 3 Not Charging problem like there is No Charging indication shows on the display when the battery charger is being a plug-in.
This problem is may cause by a faulty charger or faulty components on Xiaomi Redmi 3 PCB board. This problem may sometimes happen if the device suffered wet or water damaged or just exist.

Xiaomi Redmi 3 smartphone was launched in January 2016. The phone comes with a 5.00-inch touchscreen display with a resolution of 720 pixels by 1280 pixels.

The Xiaomi Redmi 3 is powered by 1.2GHz octa-core Qualcomm Snapdragon 616 processor and it comes with 2GB of RAM. The phone packs 16GB of internal storage that can be expanded up to 128GB via a microSD card. As far as the cameras are concerned, the Xiaomi Redmi 3 packs a 13-megapixel primary camera on the rear and a 5-megapixel front shooter for selfies.

The Xiaomi Redmi 3 runs Android and is powered by a 4100mAh non-removable battery. It measures 139.30 x 69.60 x 8.50 (height x width x thickness) and weigh 144.00 grams.

Before proceeding, ensure that the battery and the battery charger are in good working condition.
– Check all the components shown in the image below, you may start by checking the USB pin connector.
– Then the fuse, diode, capacitors and filter coil for possible open or short circuit.
– Trace each of the connection line paths from USB pins down to the components where it is directly connected.

READ MORE:-  Xiaomi Redmi Note 3 Touch Screen Not Working Problem Repair Solution

Hardware Solution:

Xiaomi Redmi 3 Charging Problem Solution USB Ways - Xiaomi Redmi 3 Charging Problem Solution USB Ways

Before doing, Be sure to check the battery and charger are Exactly working condition. then verify the phone’s USB pin connector is broken or any fault.
Check the charging (+) and (-) line paths are short using a multimeter, if it shows short them, remove/replace the diode, capacitors and filters. also, replace the fuse. Note: Use these work at your own risk.
Check all the components shown in the image below.

Note: Every repairing solution posted here is tested by at least one member of our team. Use the information available here at Your Own Risk. We are not responsible if any harm comes to your device during the repairing process.
Xiaomi Redmi 3  Charging Solution Jumper Problem Ways No Charging Not Supported

You might also like

Leave A Reply

Your email address will not be published.

92 Shares
Share92
+1
Tweet
Pin