Samsung Galaxy J7 J710F Charging Ways Solution USB Jumper
Samsung SM-J710F Charging Solution Usb Ways Usb Not Working Problem Charging Solution Fake Charging Problem
Samsung Galaxy J7 J710F Charging Ways Charging Jumper Here is the solution for Samsung SM-J710F Not Charging problem like there is No Charging indication shows on the display when the battery charger is being a plug-in.
This problem is may cause causality charger or faulty components on Samsung Galaxy J7 J710F PCB board. This problem may sometimes happen if the device suffered wet or water damaged or just exist.
Samsung Galaxy J7 (2016) smartphone was launched in March 2016. The phone comes with a 5.50-inch touchscreen display with a resolution of 720 pixels by 1080 pixels. Samsung Galaxy J7 (2016) price in India starts from Rs. 11,750.
The Samsung Galaxy J7 (2016) is powered by 1.6GHz octa-core processor and it comes with 2GB of RAM. The phone packs 16GB of internal storage that can be expanded up to 128GB via a microSD card. As far as the cameras are concerned, the Samsung Galaxy J7 (2016) packs a 13-megapixel primary camera on the rear and a 5-megapixel front shooter for selfies.
The Samsung Galaxy J7 (2016) runs Android 6.0.1 and is powered by a 3300mAh removable battery. It measures 151.70 x 76.00 x 7.80 (height x width x thickness) and weigh 170.00 grams.
The Samsung Galaxy J7 (2016) is a dual SIM (GSM and GSM) smartphone that accepts Micro-SIM and Micro-SIM. Connectivity options include Wi-Fi, GPS, Bluetooth, USB OTG, 3G and 4G (with support for Band 40 used by some LTE networks in India). Sensors on the phone include Proximity sensor, Accelerometer and Ambient light sensor.
There are a lot of factors to consider as far as charging problem is concerned and it’s not really that easy to spot where the problem is. It is, therefore, necessary to use technical deduction when troubleshooting. It means that we will have to rule out one possibility after another and we will base that on the possible causes, such as…
- Damaged or defective charger
- Broken USB cable or cord
- Busted battery
- Loose USB or utility port
- Phone has liquid damage
- Device has physical damage
Before proceeding, ensure that the battery and the battery charger are in good working condition.
– Check all the components shown in the image below, you may start by checking the USB pin connector.
– Then the fuse, diode, capacitors and filter coil for possible open or short circuit.
– Trace each of the connection line paths from USB pins down to the components where it is directly connected.
Hardware Solution
Before doing, Be sure to check the battery and charger are Exactly working condition. then verify the phone’s USB pin connector is broken or any fault.
Check the charging (+) and (-) line paths are short using a multimeter, if it shows short them, remove/replace the diode, capacitors and filters. Also, replace the fuse. Note: Use these work at your own risk.
Check all the components shown in the image above.
Note: Every repairing solution posted here is tested by at least one member of our team. Use the information available here at Your Own Risk. We are not responsible if any harm comes to your device during the repairing process.
Samsung Galaxy J7 J710F Charging Solution Jumper Problem Ways No Charging Not Supported
