Nokia 3310 Earpiece Speaker Problem Repair Solution

Nokia 3310 Earpiece Speaker Problem Repair Solution
Nokia 3310 Speaker Ways Earpiece Solution Ear Speaker Not Working Problem Repair Solution Headset Ways Ringer Jumper

Earpiece or as some people call it speaker is placed on the top front of Nokia 3310. It is used for listening phone calls nothing else. All the other sounds come out of IHF speaker which is placed on the back bottom of the mobile phone. So if you can’t listen to the person on the other end of a phone call unless you open up the loudspeaker option from within the phone, your earpiece is faulty and you need to change it.

Earpieces are fragile parts and any kind of mishandling can cause them to break down. Normally changing Nokia 3310 earpiece is pretty straight forward since it is not soldered on the motherboard all you have to do is remove the old one from the external casing and place a new one in its place. But if that does not work or if your earpiece module is okay but you still can’t listen to a phone call then you are going to have to make the jumpers as shown in this diagram.

Please Note that we will edit these solutions or add new ones if found in this page at any time in the future. So feel free to come back any time on this page to stay up to date.

Here are Nokia 3310 earpiece jumper ways. Please study these diagrams very carefully before you start repairing.

Nokia 3310 Earpiece Speaker Problem Repair Solution

  • Now Check connection between each pin of on-board connector and speaker terminals (Pin of Connector with –ve terminal of speaker and Pin of Connector with +ve terminal of speaker)
  • Now Check capacitor whether it is short, as this might also be the cause of problem.
  • Check Audio IC’s coils with capacitor 1, if the coil is damaged replace it.
  • If everything else fails then heat Audio IC and check, if that doesn’t work then replace it.
READ MORE:-  Nokia X2-00 Battery Connector Ways

In order to troubleshoot, all you have to do is to follow the following steps:
Put jumper if it is faulty, as one of the reasons for this problem is that the phone heavily dropped or water damage.
Check the diode by using multi meter, if it is faulty then change it.

If you have further Questions please leave a comment.

Note: Please note that even though every solution posted on our website is tested by one or more members of our team before posting, but still we do not take any responsibility for any damage it may cause to your cell phones. Use these repairing solutions at your own risk. Thank You.

You might also like

Leave A Reply

Your email address will not be published.

Share
Tweet
Pin
+1