Xiaomi Redmi 3 Battery Connector Point Ways Jumper

Xiaomi Redmi 3 Battery Connector Point Ways Jumper

Redmi 3 Battery Connector Jumper Battery Point Ways Solution Power Problem Repair Solution Set Dead Charging Only

Xiaomi Redmi 3 battery Low then Shutdown or restart set dead fault caused by either a faulty resistor and capacitor. Here we want to share the experience how to repair this kind of damage.

Xiaomi Redmi 3 smartphone was launched in January 2016. The phone comes with a 5.00-inch touchscreen display with a resolution of 720 pixels by 1280 pixels.

The Xiaomi Redmi 3 is powered by 1.2GHz octa-core Qualcomm Snapdragon 616 processor and it comes with 2GB of RAM. The phone packs 16GB of internal storage that can be expanded up to 128GB via a microSD card. As far as the cameras are concerned, the Xiaomi Redmi 3 packs a 13-megapixel primary camera on the rear and a 5-megapixel front shooter for selfies.

The Xiaomi Redmi 3 runs Android and is powered by a 4100mAh non removable battery. It measures 139.30 x 69.60 x 8.50 (height x width x thickness) and weigh 144.00 grams.

Damage to the battery Xiaomi Redmi 3  could be of the causes for the phone does get wet, padded seat battery connector corroded and rusted breaking lines.

Here are tips on battery connector lines, check the track as in the picture below, if there is a path-breaking or not, if there is a path-breaking try doing jumpers carefully to avoid short-circuit condition of the phone.

Hardware Solution:
Xiaomi Redmi 3 Battery Connector Point Ways Jumper - Xiaomi Redmi 3 Battery Connector Point Ways Jumper
“any damage resulting from the tips is not our responsibility”

Diagnostics:
If  Xiaomi Redmi 3 is not getting power ON, Replace the battery and try to power it ON. Plug in charging pin into the jack and try to make it charge. Check battery terminal’s +v and -V points with electronics meter.

READ MORE:-  Repair Xiaomi Redmi 2 Dead Problem Short Solution

Solution:
Disassemble the phone Samsung SM-120H and check battery connectors if these are loose or not fix. Then check the whole mother board for water and rust damages, Carbon or broken parts.
If find some rust or carbon make it clean with electronics cleaner and apply hot air with a heat gun to make it dry.
Find out these parts that are identified in above diagram and make a check for volts. If find some broken parts or tracks are missing then apply jumpers as given in above diagrams.
Xiaomi Redmi 3, Battery Terminal, Battery Points, Battery Jack Problem, Battery Terminal Solution, Battery Terminal Jumpers, Battery Power Ways

You might also like

Leave A Reply

Your email address will not be published.

0 Shares
Share
+1
Tweet
Pin