Xiaomi Redmi Note USB Ways Solution Charging Jumper


Xiaomi Redmi Note USB Ways Solution Charging Jumper
Xiaomi Redmi Note 1 Charging Solution Charging Ways Not Charging Problem USB Ways Fake Charging Problem

Here is the solution for Xiaomi Redmi Note 1 Not Charging problem like there is No Charging indication shows on the display when the battery charger is being a plug-in.
This problem is may cause by faulty components Xiaomi Redmi Note PCB board. This problem may sometimes happen if the device suffered wet or water damaged or just exist

For those that own a Huawei Ascend Y330, you may be having a problem that the Xiaomi Redmi Note not charging correctly. Some Redmi Note 1 owners thought that the USB cable was an issue for the Xiaomi Redmi Note not charging. So they went out and purchased a new charger, instead, some quick methods that we’re about to suggest can generally fix the problem when the Xiaomi Redmi Note not charging when plugged in.

Below are the most common causes of why you Xiaomi Redmi Note  have trouble charging, and other problems concerning the battery like the grey battery issue:

  • Sunken sockets on the device, or bent/ broken connector
  • Factory-defective phone
  • Defective battery
  • Damaged charging unit or cable
  • Defective phone
  • Temporary battery issue

Hardware Solution:

Xiaomi Redmi Note USB Ways Solution Charging Jumper

Check Charging connector for any kind of water damage, if it is then clean it and check.

Now re-solder charging connector pins and check.
Check charging voltage with the help of a multimeter. Place Negative terminal of the multimeter on ground and Positive on a charging pin (1st pin from your left-hand side).
Make sure that the voltage is between 5V to 5.5V, if it is not then replaced charging connector. (Charging Connector can be replaced by heating it from the opposite side of the board, while heating it, pull charging connector with the help of Tweezers).
Now remove metal sheet covering the charging section (It contains Charging IC and Components).
Check continuity between Fuse and Charging Pin (1st from your left-hand side). If there is no continuity, place jumper.
Also, check the following, and replace them if damaged:
Heat charging IC, if it is faulty then replace it.
Now check charge at the battery terminals, if it is not standard voltage then re-solder or replace battery terminals.

Read More:-  Redmi 4A Backlight Ways | Display Light Problem Solution

Xiaomi Redmi Note Charging Jumper.USB Ways, Not Charging Problem Redmi Note 1 Charging Solution, Xiaomi Redmi Note Charging Ways

Leave A Reply

Your email address will not be published.