Repair iPhone 6s Backlight Problem Display Light Ways


Repair iPhone 6s Backlight Problem Display Light Ways
Apple iPhone 6s Display Ways White LCD Solution Blank Display Problem Backlight Jumper Display Problem Repair Solution

In this post solutions for IPhone 6s LCD Problem are available. So if your IPhone 6s LCD is not working diagrams in this article can help you solve that problem.

Display problems in phones are surely considered to be one of the worst ones, and this is because a person has to do something on immediate basis in order to overcome this problem, and the worst thing is that this is known to be one of the most expensive repairer solutions as compared to others.

Apple iPhone 6s smartphone was launched in September 2015. The phone comes with a 4.70-inch touchscreen display with a resolution of 750 pixels by 1334 pixels at a PPI of 326 pixels per inch. Apple iPhone 6s price in India starts from Rs. 31,114.

Apple iPhone 6s comes with 2GB of RAM. The phone packs 16GB of internal storage that cannot be expanded. As far as the cameras are concerned, the Apple iPhone 6s packs a 12-megapixel primary camera on the rear and a 5-megapixel front shooter for selfies.

The Apple iPhone 6s runs iOS 9 and is powered by a 1715mAh non removable battery. It measures 138.30 x 67.10 x 7.10 (height x width x thickness) and weighs 143.00 grams.

Reasons of Problems

LCD screen of IPhone 6s has gone through some sort of physical damage (most of the time this is the case of Display problems in IPhone 6s.
LCD screen of phone or the phone itself might have encountered any kind of water damage.
Software is outdated.
Display connector might be loose, causing any of the above-mentioned problems in your phone’s screens.
LCD might be faulty itself, and you need to change that in order to overcome this issue.
On-board connector might be water damaged or faulty.

Read More:-  IPhone 5 Sim Card Not Detected Problem Solution

Hardware Solution:
Repair iPhone 6s Backlight Problem Display Light Ways

” Note: ensure that the LCd is okay or try replacing it before proceeding”
1. Check the LCD pin connector for possible damaged, resolder if necessary.
2. Trace each of the LED + (positive and LED – (negative connection line paths down to the resistors where it is being connected.
3. Check the connected resistor, replace if found damaged.
4. Check the volts battery voltage (VBAT) across the inductor coil, check also the coil for possible open circuit.
5. If the voltage reading is okay and the coil is good. Replace the the LED driver IC

If you have further questions please don’t hesitate to leave a comment.

Note: Every repairing solution posted here is tested by at least one member of our team. Use the information available here at Your Own Risk. We are not responsible if any harm comes to your device during the repairing process.

Apple iPhone 6s LCD Display Light,Display Light Problem,Display Light Solution,Display Light Jumpers,IPhone 6s Display Light Ways,White Display ,Blinking Display,Blank Display Problem

Leave A Reply

Your email address will not be published.