Xiaomi Redmi Note 3 Charging Problem Ways Solution


Xiaomi Redmi Note 3 Charging Problem Ways Solution
Redmi Note 3 Charging Solution Charging Ways Not Charging Problem USB Ways Fake Charging Problem Charging IC Solution

Here is the solution for Xiaomi Redmi Note 3 Not Charging problem like there is No Charging indication shows on the display when the battery charger is being a plug-in.
This problem is may cause by faulty components Xiaomi Redmi Note 3 PCB board. This problem may sometimes happen if the device suffered wet or water damaged or just exist


For those that own a Xiaomi Redmi Note 3, you may be having a problem that the Xiaomi Redmi Note 3 not charging correctly. Xiaomi Redmi Note 3 owners thought that the USB cable was an issue for the Samsung not charging. So they went out and purchased a new charger, instead, some quick methods that we’re about to suggest can generally fix the problem when the Xiaomi Redmi Note 3 not charging when plugged in.

Below are the most common causes of why you Xiaomi Redmi Note 3 have trouble charging, and other problems concerning the battery like the grey battery issue:

  • Sunken sockets on the device, or bent/ broken connector
  • Factory-defective phone
  • Defective battery
  • Damaged charging unit or cable
  • Defective phone
  • Temporary battery issue

Hardware Solution:

Xiaomi Redmi Note 3 Charging Problem Ways Solution

Check Charging connector for any kind of water damage, if it is then clean it and check.

Now re-solder charging connector pins and check.
Check charging voltage with the help of a multimeter. Place Negative terminal of the multimeter on ground and Positive on a charging pin (1st pin from your left-hand side).
Make sure that the voltage is between 5V to 5.5V, if it is not then replaced charging connector. (Charging Connector can be replaced by heating it from the opposite side of the board, while heating it, pull charging connector with the help of Tweezers).
Now remove metal sheet covering the charging section (It contains Charging IC and Components).
Check continuity between Fuse and Charging Pin (1st from your left-hand side). If there is no continuity, place jumper.
Also, check the following, and replace them if damaged:
Heat charging IC, if it is faulty then replace it.
Now check charge at the battery terminals, if it is not standard voltage then re-solder or replace battery terminals.

Read More:-  Xiaomi Redmi 8 Backlight Ways Repair Display Light Problem

Xiaomi Redmi Note 3 Charging Jumper.USB Ways, Not Charging Problem, Charging Solution,

Leave A Reply

Your email address will not be published.