Meizu M6 Note (MSM8953) Test Point EDL Pinout Ways

Meizu M6 Note (MSM8953) Test Point EDL Pinout Ways

Methods To Enter EDL Mode Meizu M6 Note EDL(9008) Mode Solution Meizu M6 Note Flashing

As you know on Meizu M6 Note (MSM8953) you will not able to enter to edl mode neither using edl USB Cable nor using the EDL command or options. So the question is how you can enter or boot to edl mode on Meizu M6 Note? and you are at right place to know and understand the complete process to use edl mode on Meizu M6 Note. To use edl mode on this model, you just need to identify the EDL test point on the motherboard of the phone, if you find the correct test point then just connect these 2 points and you are done, and the phone will now detect on your computer. Now you can easily flash firmware on your Mi phone and also you can remove mi account of the phone.

Meizu officially locked the bootloader by reasoned to improve security system. Of course not all devices, only the latest. The impact, we can no longer flash device through fastboot. Another method to flash Nokia phones is through EDL Mode. But there are still many Xiaomi users who do not know how to get a device into EDL Mode, the reason is enter EDL Mode is more complicated than going to Fastboot. Sometimes special tools are needed.

What is EDL Mode?

EDL stands for Emergency Download Mode. This mode is like an emergency door to transfer the android operating system (stock ROM) from computer to EMMC via processor when your device is boot loop, hard brick, or dead boot. The EDL Mode feature is available on Qualcomm Snapdragon devices.

READ MORE:-  Vivo V7 EDL Mode PINOUT [Vivo V7 Test Points]

Meizu M6 Note (MSM8953) Test Point  Ways

Meizu M6 Note MSM8953 Test Point EDL Pinout Ways

A surface-mounted test point is basically a small wire loop designed as an attachment point for test probes on a circuit board containing surface-mount components. It is relatively small, about the same size as a standard chip capacitor package.

The location of test points on each type of phone will vary depending on the type of PCB. On Qualcomm phones generally provided test points to force the device into emergency download mode (9008).

Preparation:

– Paper clip, Copper wire, Tweezers
– Special screwdriver for opening hp
– Mi PC Suite and Mi Flashtools (skip for the existing ones)
– Rom Fastboot Meizu M6 Note
– USB cable Nokia 2
– Operator SIM card

How To Enter EDL Mode:

– Open Back Cover Meizu M6 Note using SIM Used Operator and then use a screwdriver to open the bolt
– When it is open, please remove the flexible battery label, then leave it for a few minutes and reconnect
– You notice the two dots in the image below that are close together
– Connect the other end of the USB cable to the computer and the other end of the USB cable to Meizu M6 Note (MSM8953)
– Run device manage> note the USB port, what Nokia 2 you are Qualcomm’s HS-USB Diagnostics 9008E, if yes you take Tweezers or copper wire then samsungkan to point Test Point that you have seen in the image just to change the Qualcomm HS- USB Diagnostics 9008
– When it becomes a Qualcomm USB Port of HS-USB Diagnostics 9008 then you can Flashing Meizu M6 Note you as usual
– Wait for Flashingnya process is complete
– Congratulations Meizu M6 Note (MSM8953)  you have recovered from the dead

You might also like

Leave A Reply

Your email address will not be published.

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More

Share22
Tweet
Pin
+1
22 Shares