Download Samsung Galaxy J7 Prime G610F Touch Screen Problem Fix Firmware
Samsung G610F Touch Problem Solution Touch Screen Not Working Problem Flash File
In recent days, many Samsung Galaxy J7 Prime G610F users might have been crying as the touchscreen of their beloved device was not responding after they had updated their phone to the Android 8.1 Oreo version. If you are using a Samsung Galaxy J7 Prime G610F and facing the same issue, then this post will share a solution for you. You will not have to spend hundreds of dollars fixing hardware on your device. This issue can be fixed just by flashing the software. Don’t waste the time anymore, let’s start fixing Touchscreen not responding on your Samsung Galaxy J7 Prime G610F.
Download Files:
Very simple, you need to download firmware 6.0 or 7.0 and flash with odin 3.12
-
G610FDXU1APK2_OLB1APK2.zip 6.0
-
G610FDXU1BRB3_OLB1BRB3.zip 7.0
-
Samsung Usb Driver – Download
-
Odin Tool- Download
How To Flash Samsung Galaxy J7 Prime G610F Touch Screen Problem Fix Firmware With Odin Tool
- Download and extract the downloaded “Samsung Galaxy J7 Prime G610F firmware zip” file on pc. [This stock ROM contain 5 files .md5 format]
- Download ODIn tool and run Odin.exe file as administrator on pc. [Don’t close the tool. We will use it in next step]
- Now come to the device and boot it into DOWNLOADING Mode [ODIN Mode] manually.
Power Off the device properly.
Press & Hold Volume Down key + Volume Up key together and insert USB cable at the same time.
Now you will see the warning message on phone screen.
Next, press volume up key for once to continue to boot into Downloading mode. [Device should be into “Odin Mode”]
- Open Odin tool again and this time you will see “added” message in log window, if the device is properly connected with pc into download mode.
- Now load all the flash files in appropriate section. Samsung Galaxy J7 Prime G610F firmware contain 5 files. Load all the files in Odin tool in appropriate section.]
Click on “BL” and load BL flash file from Extract firmware folder
Click on “AP” and load AP flash file from Extract firmware folder
Click on “CP” and load CP flash file from Extract firmware folder
Click on “CSC” and load CSC flash file from Extract firmware folder
- Finally hit on “START” button to start firmware flashing process. [Don’t touch or remove USB cable during the firmware flashing process]
- After completing the flashing process, you will see green “PASS” message on the tool and device will restart again.
Note:First Time It Takes 7-10 Minutes To Boot
