iPhone 6S Full Charging Ways – Charging Problem Solution

0

iPhone 6S Full Charging Ways – Charging Problem Solution

Here is the solution for iPhone 6S Not Charging problem like there is No Charging indication shows on the display when the battery charger is being a plug-in.
This problem is may cause by faulty components iPhone 6S PCB board. This problem may sometimes happen if the device suffered wet or water damaged or just exist

For those that own an iPhone 6S, you may be having a problem that the iPhone 6S not charging correctly. iPhone 6S owners thought that the USB cable was an issue for the iPhone 6S not charging. So they went out and purchased a new charger, instead, some quick methods that we’re about to suggest can generally fix the problem when the iPhone 6S not charging when plugged in.

Below are the most common causes of why you iPhone 6S have trouble charging, and other problems concerning the battery like the grey battery issue:

  • Sunken sockets on the device, or bent/ broken connector
  • Factory-defective phone
  • Defective battery
  • Damaged charging unit or cable
  • Defective phone
  • Temporary battery issue

iPhone 6S Ful Charging Ways Problem Hardware Solution:

iPhone 6S Full Charging Ways Charging Problem Solution

Check Charging connector for any kind of water damage, if it is then clean it and check.

Now re-solder charging connector pins and check.
Check to charge voltage with the help of a multimeter. Place Negative terminal of the multimeter on ground and Positive on a charging pin (1st pin from your left-hand side).
Make sure that the voltage is between 5V to 5.5V, if it is not then replaced charging connector. (Charging Connector can be replaced by heating it from the opposite side of the board, while heating it, pull charging connector with the help of Tweezers).
Now remove metal sheet covering the charging section (It contains Charging IC and Components).
Check continuity between Fuse and Charging Pin (1st from your left-hand side). If there is no continuity, place jumper.

READ MORE:-  iPhone 5s Front Camera Not Working Problem Jumper Solution

Also, check the following, and replace them if damaged:
Fuse
Capacitor
Coil
Heat charging IC, if it is faulty then replace it.
Now check charge at the battery terminals, if it is not standard voltage then re-solder or replace battery terminals.

Leave a Reply

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. AcceptRead More