Repair iPhone 12 Pro Max Charging Problems | Charging Ways
In this post, we will deal with the iPhone 12 Pro Max not charging problem, Charging Ways, USB Jumper Solution since charging is one of the most important processes that need to work no matter what. This phone has a monster battery (3678 mAh) and it could last for a few days if used for texting, calling, and browsing. But such hardware will be rendered useless if the device won’t charge. So, let’s try to take a closer look into this problem to know if there’s something we can do about it.
iPhone 12 Pro Max Charging problems are often complicated as it may be due to an issue in the hardware or perhaps, the firmware is having some problems as well. The most challenging part is to determine which is which and that’s what this post is all about. Before we proceed with the steps, try to read one of the problems that best describes this issue.
Hardware Reasons for iPhone 12 Pro Max Charging Problem
There are four basic hardware-related reasons that your iPhone 12 Pro Max could be charging slowly, and I will explain each of them in turn and in order of increasing probability. The issue could be:
- There is dirt, dust, or debris lodged in the charging port.
- The power adapter is damaged or faulty.
- The USB cable is no longer working properly.
- You are using the wrong power adapter for your phone, or a weak USB port.
iPhone 12 Pro Max Charging Ways – USB Charging Problem Solution
In the below image we draw the Apple iPhone 12 Pro Max charging ways and its jumper check continuity using a multimeter if any track damage makes a jumper on the iPhone 12 Pro Max motherboard.
- First, open the mobile
- Then clean the section of the charging connector of the mobile motherboard
- Then remove the old charging connector and add a new connector
How To Repair iPhone 12 Pro Max Not Charging Problem:
iPhone 12 Pro Max Charging Ways Charging Jumper Solution Slow Or Fake Charging Solution
After the mobile phone disassembles, you will need to take some steps shown in the diagram above.
Check the Charging jack and its points do they have good value if yes, then change the changer and check it and if the motherboard does not see the accurate value with the charging points, then after the dissatisfaction of the mobile phone you get something shown in the above diagram You have to take steps.
Below are the most common causes of why you iPhone 12 Pro Max have trouble charging, and other problems concerning the battery like the grey battery issue:
- Shorted/faulty diode
- Shorted/faulty capacitors
- faulty resistors
- Bad/damaged charging coil
- Shorted/faulty IC
- Bad USB Port
- Partial contact
If any corrosion or carbon and water damage or any component are damaged, then the motherboard should be replaced carefully. If a track is lost then the jumper is applied and if any part is damaged or broken, replace it with the new one.
More information about this problem and solutions for new tips and tricks are going to this page, if there are new updates, there will be updates. Below are some related posts, you can read more about mobile phones.
Connect with us
We are always open to your problems, questions, and suggestions, so feel free to contact us by filling up this form. This is a free service we offer and we won’t charge you a penny for it. But please note that we receive hundreds of emails every day and it’s impossible for us to respond to every single one of them. But rest assured we read every message we receive. For those whom we’ve helped, please spread the word by sharing our posts to your friends