Redmi 6 Pro Battery Connector Ways VBAT Jumper
This Post is about repairing solution for Redmi 6 Pro battery connector ways jumper. If your phone’s battery connector is damaged somehow you can always replace it with a new one, but if the battery connector’s prints are damaged then the diagram in this article can be helpful to you.
Damage to the battery Redmi 6 Pro could be of the causes for the phone does get wet, padded seat battery connector corroded and rusted breaking lines.
Please Note that we will edit these solutions or add new ones if found on this page at any time in the future. So feel free to come back any time on this page to stay up to date.
Here are Redmi 6 Pro Battery Connector Ways Problem Solutions. Please study these diagrams very carefully before you start repairing.
Redmi 6 Pro Battery Connector Ways:
“any damage resulting from the tips is not our responsibility”
Diagnostics:
If Redmi 6 Pro is not getting power ON, Replace the battery and try to power it ON. Plug in charging pin into the jack and try to make it charge. Check battery terminal’s +v and -V points with electronics meter.
Solution:
Disassemble the phone Redmi 6 Pro and check battery connectors if these are loose or not fix. Then check the whole motherboard for water and rust damages, Carbon or broken parts.
If find some rust or carbon make it clean with electronics cleaner and apply hot air with a heat gun to make it dry.
Find out these parts that are identified in the above diagram and make a check for volts. I find some broken parts or tracks are missing then apply jumpers as given in the above diagrams.
If you have further questions please don’t hesitate to leave a comment.
Note: Every repairing solution posted here is tested by at least one member of our team. Use the information available here at Your Own Risk. We are not responsible if any harm comes to your device during the repairing process.
