Mi Note 10 QCN File Repair Null Imei On MI CC9 Pro


Mi Note 10 QCN File Repair Null Imei On MI CC9 Pro QCN File has Now been available for The Mi Note 10 and Now You can Download it From below. You can use MI CC9 Pro QCN File To Repair Null IMEI, unknown baseband, MAC & BT Address on Mi Note 10 Tucana Model.

Reasons may be different for Mi Note 10 invalid IMEI error. But most of the time Xiaomi Redmi Go IMEI invalid or Null IMEI issue accrue after flashing ROM. Because of this invalid IMEI, it will show null IMEI or invalid IMEI and you can’t make a call using the same device. It will show no network on the device.

Mi Note 10 IMEI Repair | Fix Invalid IMEI / Network Issue

Fix Invalid IMEI Error On Mi Note 10 Using IMEI Tool  For now, just forget everything and let’s see how to repair IMEI on Mi Note 10 after flash? No root required and no premium professional IMEI repair tool require to flash IMEI on the Xiaomi Qualcomm smartphone. Free Pc IMEI tool and QCN file are enough to get a ride on this IMEI problem.

Pre-Requiems To Restore IMEI On Mi Note 10

  • Charge the device approx 80%
  • Don’t forget to take the backup of the device before going to apply any changes on the device.
  • Do it on your own risk.
  • Download tools and files to repair Mi Note 10 IMEI number [ Check Download Section]
1 – Unlock Bootloader (Manual)
2 – Root (Manual )
3 – Enable Diag & Backup Qcn
4 – Efs Backup & Reset (Twrp)
5 – Imei Repair (Umt) (Sim2) 6 – Xqcn (Qfil)
Read More:-  QCN File For Xiaomi Mi 6X IMEI Repair / Fix Network Issue

Download Mi Note 10 QCN File, IMEI Repair tool and Other Files

Step01: Generate QCN File For Mi Note 10 Mobile

Run “Rebuilder tool” on pc >> “Open File” >> Browse “Mi Note 10 Eng QCN File” >>> “Replace IMEI with original IMEI Number” >> Click “Rebuild” button and save new QCN file on pc. Generate QCN File

Step02 Write Or Repair Mi Note 10 IMEI Number

  • Download QCN Rebuilder and QCN File From above
  • Run QCN Rebuilder Load Download QCN Replace IMEI With the Original IMEI then Rebuild QCN
  • Enable USB Debugging From Developer options Connect Phone to PC using USB then Enable Qualcomm USB diag port (using below code over adb)
  • Enable diag port by using *#558# Code.
  • Quality Verification Test
  • Select Debugging Port.
  • Now diag port will enable check device manager and install Qualcomm diag drivers (Qualcomm HS-USB diag 901D port will appear)
  • Launch QPST Software Downloaded Tool from above.
  • Click on the Restore Tab.
  • Choose Your Phone By Clicking on First Browse.. Button.
  • Select Rebuild QCN File ***.xqcn file [Downloaded From above].
  • Now Hit the Start Button.
redmi y1 imei reapir using qpst
  • Done.
if the Dual IMEI Writer unable to Rewrite Correct IMEI Then use hex Converter to Find and Replace Installed IMEI.
Leave A Reply

Your email address will not be published.