Redmi 8 Network Problem Repair Solution – Network Ways

0

The Solution in this post may possibly help fix and repair Redmi 8 Network Problem. Before you may proceed to use this solution, ensure that the device firmware is okay, restored, and already flashed and or updated. This solution may only work if the device suffered water damaged or heavily dropped by the user.

Redmi 8 No service, emergency calls only, and no signal errors are among the widespread issues encountered in Redmi 6A smartphone users regardless of brand and operating system the device is running on. These errors are likewise tagged among other network-related issues in mobile devices. When this problem occurs, you will not be able to send and receive texts, or make or receive calls on your device.

Redmi 8 Network Problems

No network on your phone. Low signals. The phone just searches for the network, but not connected. Constantly falling signals. Call drop issue.

Reasons for Redmi 8 Network Problems

Your SIM card may be defective. Your network operator may be having temporary difficulties. GSM antenna contact may be rusted bay or could have found some kind of powder. Contact Pines of the antenna are not adequately in touch with contacts GSM antenna. Any of the coils and capacitors’ antenna network or Power Amp IC could be defective. The secondary coil antenna may be defective.

Redmi 8 Network Problem Solution – Signal Ways

Redmi 8 Network Problem Repair Solution Network Ways

Restart your phone and  Redmi 8 and check. Remove and reinsert the SIM card and check. Switch between different network modes and control. Check with any other SIM card working, and that your SIM card or your network operator may be having problems. Redmi 8 Network Problem Solution Jumper Ways

Read More:-  Repair Redmi 8A Not Charging Problem - Charging Ways

How To Repair Redmi 8 Network Problem

Ensure that the device firmware is okay or successfully restored or flashed.

Try to upgrade to a higher version and write good flash files.

IF the firmware calibration already was done but seems nothing happens you may proceed to trace, check or replace the corresponding components showed on the solution above.

Make sure that the PCB board condition is still stable and not like bent or some damaged spots.

Check also if there is oxidation build-up, clean it first before you may proceed.

First, check the PA supply voltage, this voltage is coming from the antenna terminal and you can trace it between capacitors showed on the solution above.

Please note that we will edit these solutions or add new ones if found on this page at any time in the future. So feel free to come back any time on this page to stay up to date.

Connect with us

We are always open to your problems, questions, and suggestions, so feel free to contact us by filling up this form. This is a free service we offer, and we won’t charge you a penny for it. But please note that we receive hundreds of emails every day, and it’s impossible for us to respond to every single one of them. But rest assured we read every message we receive. For those whom we’ve helped, please spread the word by sharing our posts to your friends or by simply liking our Facebook page.

Leave a Reply

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More