Repair Samsung Galaxy A01 A013 Display Problems | LCD Backlight Ways


Hello, mobile technicians in this post we share the latest solution of Samsung Galaxy A01 A013F Backlight ways and Display light problem jumper full LCD ways display connection line paths in case you are going to troubleshoot display problem such blank display, dark screen display, white screen (with tones), No backlight LED that is resulted from due to wet damaged or accidentally dropped issues by the users.

Samsung Galaxy A01 A013 Backlight Display Problem is a typical case; surely this will be the moment when we use a lot of activities using an Android phone device, in this opportunity MobileRdx Team try to discuss and Provide a repair solution on the Android device Redmi 5 no backlight. Maybe some of you have the same obstacles and damage on Android phones Redmi 5 that have no light on the display or its LCD.

The problem of damage with no backlight is often symptomatic like an LCD that has no display, the LCD screen becomes white. Or in general, there is no light produced by the LCD screen but the ringing and notification sound can still be heard.

Handset Fault  Type.

  • Display Light not Working.
  • Display Light Circuit Damage.

What Is An Samsung Galaxy A01 Backlight or LCD Display?

To start with, an LCD is the digital display interface of your phone, it is the interactive part where you see what goes on as you operate or tap on an icon, watch a video, play music or games, etc. When the LCD (liquid crystal display) is faulty or damaged, you one won’t be able to enjoy it as before. This is where the LCD backlight comes in, the backlight is a series of LEDs (light-emitting diodes) well arranged and suited in the screen layers to give illumination to the LCD screen.

Read More:-  Samsung Galaxy J7 Prime Charging Ways Solution Jumper

Samsung Galaxy A01 A013 Backlight Ways Problem Solution

To fix the dark screen Samsung Galaxy A01 A013F backlight problem, you may first try to replace or install a new Display screen module, to easily confirm if the LCD’s backlight LED’s were still working or already damaged. You can also check the LED’s using the multimeter if you can manage without damaging the LCD flex connector. If the newly installed LCD still shows the same problem and the LED light doesn’t light up, refer to the solution below and locate the highlighted components on the PCB board. Repair Samsung Galaxy A01 A013 Display Problems   LCD Backlight Ways Download Samsung  A01 A013F Schematic Diagram Samsung A01 Core A013F Charging Ways

Following are some of the Samsung Galaxy A01 A013 Display Light problems that you might encounter:


  • White Display
  • No Display
  • Lines on Display
  • Low Light on Display
  • No Backlight

Steps To Repair Samsung Galaxy A01 A013 Backlight Ways Problem:

“Note: Ensure that the SSamsung Galaxy A01 Lcd is okay or try replacing it before proceeding.”

  • Check the LCD for possible damaged, cracked or broken. Replace if necessary.
  • Check the device firmware, and do a self-test and calibration method. update or flash the firmware.
  • Check the LCD pin connector for possible damaged. Clean, re-solder or replace if necessary.
  • Now Check Continuity between the Display connector to the resistor compounds. if any of then is track missing then make a jumper.
  • If the above procedures don’t fix the problem the possible faulty is the main engine IC. Try to re-heater rework it.

If you have further questions, please don’t hesitate to leave a comment.

Read More:-  Samsung Galaxy Ace S5830I MMC Not Working Problem Jumper Solution

Note: Every repairing solution posted here was tested by at least one member of our team. Use the information available here at Your Own Risk. We are not responsible if any harm comes to your device during the repairing process.

Leave A Reply

Your email address will not be published.