Repair Xiaomi Mi 9 SE Not Charging Problem | Charging Ways

0

Here is the tested and working solution of the Xiaomi Mi 9 SE Not Charging Problem, Charging ways, and USB jumper, This mobile charging problem does not easily make a bad part, and though it is worse, the charging connector. So this mobile charging problem arises Then first switch the charging connector. And if the problem is not resolved even after the charging connector is changed. If you see the picture that I gave the picture, your jumper. Below I’ll tell you to step by step, how do you solve this problem.

Xiaomi Mi 9 SE Charging problems are often complicated as it may be due to an issue in the hardware or perhaps, the firmware is having some problems as well. The most challenging part is to determine which is which and that’s what this post is all about. Before we proceed with the steps, try to read one of the problems that best describes this issue.

Xiaomi Mi 9 SE Charging Ways Solution

In the below image we draw the Xiaomi Mi 9 SE charging ways and its jumper check continuity using a multimeter if any track damage makes a jumper on the Redmi Note 8 Pro motherboard.

  1. First, open the mobile
  2. Then clean the section of the charging connector of the mobile motherboard
  3. Then remove the old charging connector and add a new connector
After doing this, but the mobile phone is in charge once, After doing these things, if the mobile is solved then fitting the mobile, If the problem is not solved after doing these, then I have given a picture below to do the job.

Repair Xiaomi Mi 9 SE Not Charging Problem   Charging Ways

Hardware Reasons for Xiaomi Mi 9 SE Charging Problem

How To Repair Xiaomi Mi 9 SE Not Charging Problem:

Xiaomi Mi 9 SE Charging Ways Charging Jumper Solution Slow Or Fake Charging Solution

After the mobile phone disassembles, you will need to take some steps shown in the diagram above.

Check the Charging jack and its points do they have good value if yes, then change the changer and check it and if the motherboard does not see the accurate value with the charging points, then after the dissatisfaction of the mobile phone you get something shown in the above diagram You have to take steps.

Check the Charging jack and its points are good values if yes, then change the changer and check it and if the motherboard does not see the accurate value with charging points, then you will see all the parts and tracks given in the diagram of Xiaomi Redmi 10X Are to investigate.

If any corrosion or carbon and water damage or any component are damaged, then the motherboard should be replaced carefully. If a track is lost then the jumper is applied and if any part is damaged or broken, replace it with the new one.

More information about this problem and solutions for new tips and tricks are going to this page, if there are new updates, there will be updates. Below are some related posts, you can read more about mobile phones.

Leave A Reply

Your email address will not be published.