Repair Xiaomi Redmi 8A Pro Charging Ways | USB Charging Solution

0

Looking for Xiaomi Redmi 8A Pro Charging Problem repair solution, USB jumper how to repair Redmi 8A charging ways then you landed at the right place here you fill find full detail diagram of charging problem ways, battery connector jumper and charging solution.

If you encounter any problems such as damage to Xiaomi Redmi 8A Pro charging ways not charging problem solution Charging paused or slow charging, here we will give you suggestions on resolving this problem with your phone. For example, you will be unable to charge your phones using the phone’s direct USB chargers, the universal charger usage becomes impossible when you use a phone powered by an inbuilt battery.

When a premium device like the Xiaomi Redmi 8A Pro won’t charge, the Charging ways solution the problem can be with the hardware and its accessories, or it could be just a minor issue with the firmware. As an owner, you should do some troubleshooting procedures to determine what the issue is and hopefully be able to fix it.

Hardware Reasons for Xiaomi Redmi 8A Pro Charging Problem

There are four basic hardware-related reasons that your Xiaomi Redmi 8A Pro could be charging slowly, and I will explain each of them in turn and in order of increasing probability. The issue could be:

  1. There is dirt, dust, or debris lodged in the charging port.
  2. The power adapter is damaged or faulty.
  3. The USB cable is no longer working properly.
  4. You are using the wrong power adapter for your phone, or a weak USB port.
Read More:-  Xiaomi Redmi 5 Headphone Logo Problem - Handsfree Mode Solution

Xiaomi Redmi 8A Pro Charging Ways – Not Charging Problem Solution

In the below image we draw the Xiaomi Redmi 8A Pro charging ways and its jumper check continuity using a multimeter if any track damage makes a jumper on the Xiaomi Redmi 8A Pro motherboard.

Repair Xiaomi Redmi 8A Pro Charging Ways USB Charging Solution

  1. First, open the mobile
  2. Then clean the section of the charging connector of the mobile motherboard
  3. Then remove the old charging connector and add a new connector

Here Are Some Steps to Resolve Xiaomi Redmi 8A Pro Charging Problem:

1. Check The Usb Charging Port

Cause no charging damage to Xiaomi Redmi 8A Pro can be caused by the destruction of the USB port corrosion.
So that the line is disconnected and the voltage can not flow and drain and saved to the battery of the phone. Change the charging USB port immediately, if it is damaged and causes no charger problems on the phone.

2. Check Components And Lines

Perform a line check on the board if there is damage or disconnected lines, apply the way jumper on the PCB board. And also do an inspection of components that can cause no charging damage to occur, make changes to the component.

On the diagram image listed above, there is a component that has a malfunction of Xiaomi Redmi 8A Pro no charging phone. Then for his best move immediately replace the defective component with a replacement component with good condition.

But if you do not have a replacement component, then it can do away jumper only on the component that suffered the damage.
By doing some of these ways can fix Redmi 8A Pro not charging, make sure you do the damage inspection carefully. Use the Multimeter tool to measure conditions on each component and path on a damaged PCB board.

Read More:-  Xiaomi Redmi Note 4 Charging Problem Ways Solution

That’s some way to fix Huawei P20 Lite not charging because it’s a problem of damage like this very often happens. For more information and new tips and tricks on the solution to the problem of other Android phones. Continue to visit this page. We will update it if there is a new update.

Leave A Reply

Your email address will not be published.