Repair Redmi Note 10 Pro Not Charging Problem | Charging Ways


In this post, we will tackle the not charging issue on the Xiaomi Redmi Note 10 Pro Charging Ways, and its jumper solution, a mid-range device with impressive specs. After providing support to Android users for years, we can already predict that this kind of power-related issue would be among the first ones Xiaomi Redmi Note 10 Pro owners may encounter. That is why we find it necessary to publish articles like this because we know one-day complaints about this problem will come rushing into our inboxes.

Samsung recently announced a new budget smartphone under their Note 10 series. This is the Redmi Note 10 Pro, and so far it has only been announced. It is expected to hit different markets around the world in the first quarter of 2021. In this tutorial, we will guide you on how to repair the Charging Problem on the Redmi Note 10 Pro.

When a premium device like the Xiaomi Redmi Note 10 Pro won’t charge, the Charging ways solution the problem can be with the hardware and its accessories, or it could be just a minor issue with the firmware. As an owner, you should do some troubleshooting procedures to determine what the issue is and hopefully be able to fix it.

Xiaomi Redmi Note 10 Pro Device Overview

The Redmi Note 10 Pro was announced on the 4th of March, 2021. The smartphone features a 6.67-inch AMOLED display with a resolution of 1080 x 2400 pixels and an aspect ratio of 20:9. It has a refresh rate of 120Hz and a peak brightness of 1200 nits. Under the hood, we have the Qualcomm Snapdragon 732G.

Read More:-  Redmi Note 5A LCD Light Ways Backlight Jumper Solution

We have a quad-camera setup at the rear and a single camera at the front. The quad setup consists of a 64MP primary sensor paired with an f/1.7 lens, an 8MP ultrawide sensor paired with an f/2.2 lens, a 5MP macro sensor paired with an f/.2.4 lens, and a 2MP depth sensor paired with an f/2.4 lens. At the front, we get a single 25MP sensor paired with an f/2.5 lens which is housed in a center punch hole alignment.

.The phone runs on Android 11 with MIUI 12 skin on top of it. In terms of storage(UFS2.2) and RAM, we have three options: 6GB RAM + 64GB ROM, 6GB RAM + 128GB ROM, and 8GB RAM + 128GB ROM.

Hardware Reasons for Xiaomi Redmi Note 10 Pro Charging Problem

There are four basic hardware-related reasons that your Xiaomi Redmi Note 10 Pro could be charging slowly, and I will explain each of them in turn and in order of increasing probability. The issue could be:

  1. There is dirt, dust, or debris lodged in the charging port.
  2. The power adapter is damaged or faulty.
  3. The USB cable is no longer working properly.
  4. You are using the wrong power adapter for your phone, or a weak USB port.

Xiaomi Redmi Note 10 Pro Charging Ways -Repair Not Charging Problem

In the below image we draw the Xiaomi Redmi Note 10 Pro charging ways and its jumper check continuity using a multimeter if any track damage makes a jumper on the Xiaomi Redmi Note 10 Pro motherboard.

Repair Redmi Note 10 Pro Not Charging Problem Charging Ways

  1. First, open the mobile
  2. Then clean the section of the charging connector of the mobile motherboard
  3. Then remove the old charging connector and add a new connector.
Read More:-  Xiaomi Redmi 8 Backlight Ways Repair Display Light Problem

How To Repair Xiaomi Redmi Note 10 Pro Not Charging Problem:

1. Check The USB Charging Port

Cause no charging damage to Xiaomi Redmi Note 10 Pro can be caused by the destruction of the USB port corrosion.
Corrosion can be caused by water spills so that the pin of the port charging is damaged and the voltage transfer line is disconnected.

2. Check Components And Lines

Perform a line check on the board if there is damage or disconnected lines, apply the way jumper on the PCB board. And also do an inspection of components that can cause no charging damage occurs, and make changes to the component.

On the diagram image listed above, there is a component that has a malfunction of Xiaomi Redmi Note 10 Pro no charging phone. Then for his best move immediately replace the defective component with a replacement component in good condition.

But if you do not have a replacement component, then it can do away with the jumper only on the component that suffered the damage.
Doing some of these ways can fix Xiaomi Redmi Note 10 Pro not charging, make sure you do the damage inspection carefully. Use the Multimeter tool to measure conditions on each component and path on a damaged PCB board.

That’s some way to fix the Xiaomi Redmi Note 10 Pro not charging because it’s a problem of damage like this very often happens. For more information and new tips and tricks on the solution to the problem of other Android phones. Continue to visit this page. We will update it if there is a new update.

Read More:-  Xiaomi Mi 5X Touch Screen Ways Touch Not Working Problem Solution
Leave A Reply

Your email address will not be published.