Samsung A01 SM-A015F ISP EMMC PinOUT | Test Point | EDL test Point
You can access the ISP Pinout connection of your Samsung Galaxy A01 SM-A015F using the step-by-step guide below. You can bypass the FRP lock and reset your user data by using the ISP Pinout with a tool like the EasyJTAG Plus Box. You can find more details in the guide below.
The Samsung A01 was released recently with mid-range hardware specifications, including a Snapdragon 439 chipset, 2GB of RAM, 32GB of internal storage, and 13MP rear cameras. This guide shows the tested pinout for the Samsung Galaxy A01’s EMMC ISP and test point.
Z3x Samsung Tool, Easy JTag, and UFI Box can bypass Samsung A01 SM-A015 Fingerprint, pattern, and screen locks. It doesn’t matter how much knowledge you have of Android software; this method will make the problem disappear quickly. If you see the message “USB not recognized,” your USB doesn’t work. You can only use this method if your battery is fully charged and your USB port works properly. Remember to leave your questions in the comments; I will do my best to answer them.
What is Samsung A01 SM-A015F ISP Pinout?
eMMC ISP Pinout refers to the layout and function of the pins on a device used to program or reprogram the eMMC (embedded Multimedia Card) storage on a device. eMMC storage is a non-volatile memory used in many electronic devices, such as smartphones and tablets, to store data. The eMMC ISP Pinout allows a programmer or a device service technician to connect to the eMMC storage and perform tasks such as reading, writing, and erasing data on the eMMC.
The eMMC ISP Pinout typically consists of pins used for power, ground, data transfer, and control signals. The specific number and function of the pins can vary depending on the device and the programmer being used. Some standard pins found on an eMMC ISP Pinout include VCC (power), GND (ground), CLK (clock), CMD (command), and DAT (data).
Samsung A01 SM-A015F ISP EMMC Pinout Image:
- The back case needs to be taken off of your phone. Next, disconnect the motherboard from the camera, fingerprint reader, and battery that are already there.
- Remove the motherboard’s screws, take it out, and store it somewhere safe.
- Find the six eMMC pins on your device. These are the pins: VCC, GND, Dat 0, CLK, and VCCQ. To get to them, you will have to cut through a steel cover.
- Get the adapter out of the UFI box. In the connector I talked about in the last step, you will see the same pins.
- There are four jumpers between the base and the adapter. You need to solder Dat0, CLK, CMD, and GND. I left the VCC and VCCQ on the USB so it could turn them off.
Two of the greatest dongles on the market, the easy jtag plus and the ufi box, are required to fix a dead boot on a Samsung A01 SM-A015F, or any other brand of phone. When phones flash the wrong firmware, those boxes help them not show starting on the screen. For boot repair, you need those boxes. Some brands don’t let you remove locks like PIN, pattern, password, FRP, and MDM locks. This really allows you to remove locks.
How to Use UFS Pinout using Easy JTag
- Download the Latest Easy Jtag Setup From here
- Locate the PinOUT/Test Point on your device by looking at the image above.
- Make sure you follow the software guidelines. Alternatively, you can use the Z3X Samsung Tool Pro
Thank you for reading this guide on finding Samsung Galaxy A01 SM-A015F