Nokia 108 Local Mode Test Mode Problem Solution

Nokia 108 Local Mode Solution

nokia 108 test mode local mode problem solution found.here is a diagram that will help you to solve test mode and local mode problem in nokia 108 look at the diagram and carefully remove these parts resistance as shown in diagram given with this post.

In Nokia 108 Local Mode or Test Mode problems occur because of the Software Problems, in some cases it may be caused by hardware problems too. Whenever you get this problem First thing you should do is Flash your phone with same or Latest Firmware of the Cell Phone available at the time. Then write a good Permanent Memory(PM) file of your phone. Then Do a complete Unlock and check if the Problem is solved. Before Doing any hardware solution you should clean the Motherboard of the Mobile Phone.

Please Note that we will edit these solutions or add new ones if found in this page at any time in the future. So feel free to come back any time on this page to stay up to date.

Solution 1
local mode copy1

Solution 2
local copy1

If you have further Questions please don’t hesitate to leave a comment.

Note: Every diagram we post on Mobilerdx.com is tested by one or more members of our team. Still Use them at Your Own Risk we are not responsible if these solutions may cause any harm to your phone.

www.MobileRdx.com
READ MORE:-  Nokia 101 Display Light Ways Jumper Solution

You might also like
2 Comments
  1. Md shopan Miah says

    good solution it is very useful post for every mobile service man
    Nokia asha 501 charging solution

Leave A Reply

Your email address will not be published.

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More

Share
Tweet
Pin
+1
0 Shares