Huawei Honor Play Test Point – Remove FRP Lock Using MRT Key


Huawei Honor Play Test Point – Honor Play FRP Lock Remove Using MRT Key

Huawei Honor Play Test Point EDL 9008 Mode Ways Huawei Honor Play User Lock Remove
As you know on Huawei Honor Play you will not able to enter to edl mode neither using edl USB Cable nor using the EDL command or options. So the question is how you can enter or boot to edl mode on Huawei Honor Play? and you are at right place to know and understand the complete process to use edl mode on Huawei Honor Play.
The Honor Play runs Android 8.1 and is powered by a 3,750mAh battery. The Honor Play supports proprietary fast charging.

As far as the cameras are concerned, the Honor Play on the rear packs a 16-megapixel primary camera with an f/2.2 aperture and a second 2-megapixel camera with an f/2.4 aperture. The rear camera setup has phase detection autofocus. It sports a 16-megapixel camera on the front for selfies, with an f/2.0 aperture.

The Honor Play runs EMUI 8.2 based on Android 8.1 and packs 64GB of inbuilt storage that can be expanded via microSD card (up to 256GB). The Honor Play is a dual-SIM (GSM and GSM) smartphone that accepts Nano-SIM and Nano-SIM cards.

To use edl mode on this model, you just need to identify the EDL test point on the motherboard of the phone, if you find the correct test point then just connect these 2 points and you are done, and the phone will now detect on your computer. Now you can easily flash the firmware on your Mi phone and also you can remove mi account of the phone.


So dear viewers please study the below-mentioned process and use it on your phone to boot to edl mode on Huawei Honor Play. This is also called force edl mode on mi phones.

Huawei Honor Play Test Point

How To Remove FRP Lock From Huawei Honor Play Using MRT Key:

  1. First download and install MRT key Latest setup fro here
  2. After download open MRT key tool select MRT HW Flash tool
  3. Now Select USB 1.0 Com CPU Type Hisi_970

Huawei Honor Play frp remove

Huawei Honor Play frp remove done


– Paper clip, Copper wire, Tweezers
– Special screwdriver for opening hp
– Mi PC Suite and Mi Flashtools (skip for the existing ones)
– Rom Fastboot Huawei Honor Play
– USB cable Huawei Honor Play
– Operator SIM card

How To Use Huawei Honor Play Testpoint:

– Open Back Cover Huawei Honor Play using SIM Used Operator and then use a screwdriver to open the bolt
– When it is open, please remove the flexible battery label, then leave it for a few minutes and reconnect
– You notice the two dots in the image below that are close together
– Connect the other end of the USB cable to the computer and the other end of the USB cable to Huawei Honor Play
– Run device manage> note the USB port, what Huawei Honor Play you are Qualcomm’s HS-USB Diagnostics 900E, if yes you take Tweezers or copper wire then short  to point Test Point that you have seen in the image just to change the Qualcomm HS- USB Diagnostics 9008
– When it becomes a Qualcomm USB Port of HS-USB Diagnostics 9008 then you can Flashing Huawei Honor Play you as usual
– Wait for Flashingnya process is complete
– Congratulations Huawei Honor Playyou have recovered from the dead
Leave A Reply

Your email address will not be published.