Huawei Mate 10 Lite ISP Pinout – EMMC Pinout Dead Boot Repair


Huawei Mate 10 Lite ISP Pinout – EMMC Pinout Dead Boot Repair

Hello, mobile technician If you are searching for Huawei Mate 10 Lite ISP Pinout then you landed at right place. in this post, you will file Huawei Mate 10 Lite ISP Pinout for remove User Lock And Pattern Lock Bypass Frp Lock and also you can use this isp pinout for flashing.

Here is the  Huawei Mate 10 Lite can be used to overcome some software problems on Huawei Mate 10 Lite phone, to direct it you can use a flasher box that has direct isp feature support and usually the flasher box can also be used for repairing emmc like Easy Jtag, Ufi, etc.

Huawei Mate 10 Lite Specifications

Huawei Mate 10 Lite smartphone was launched in October 2017. The phone comes with a 5.90-inch touchscreen display with a resolution of 1080×2160 pixels.

Huawei Mate 10 Lite is powered by a 1.7GHz octa-core HiSilicon Kirin 659 processor. It comes with 4GB of RAM.

The Huawei Mate 10 Lite runs Android 7.0 and is powered by a 3340mAh non-removable battery.

Before removing or replacing IC eMMC you should do Direct eMMC first, still, discuss a little about and pinch, it turns out the partitions don’t match. for eMMC, use KMKJS, use the new boss, don’t use the 2nd one, what is 2nd, 2nd is the second boss of the former emmc who died or asks for TP because of the UFI BOX there support TP eMMC Samsung brand we can’t mention one by one because there are many from that by the eMMC owner the TP was revived and sold at a cheap price.

Read More:-  Honor X6 EMMC ISP Pinout | Test Point Image

Huawei Mate 10 Lite ISP (EMMC) Pinout

Okay, just follow this Direct eMMC Huawei Mate 10 Lite Pinout, please download

Huawei Mate 10 Lite ISP Pinout EMMC Pinout Dead Boot Repair

So that later when you want to direct again you are not confused looking for the Direct Pin, please boss just save it on HDD boss so that at any time there are cases that can be used again.

Please jumper for VCC VCCQ CLK CMD D0 GND for GND or ground don’t forget the jumpers are also bosses, otherwise, the jumpers don’t connect later.

Clear User Lock, you can try using ISP method via UFI eMMC ToolBox, use “Factory Reset” under Special Task in User Partition Tab. Or using AETOOL by MRTkey (Android Emmc Tool).

Leave A Reply

Your email address will not be published.