Vivo Y17 EMMC Pinout For Remove User Lock And FRP


Vivo Y17 EMMC Pinout For Remove User Lock And FRP

Hey, mobile technician If you are searching for Vivo Y17 ISP Pinout then you landed at right place. in this post, you will file Vivo Y17 ISP Pinout for remove User Lock And Pattern Lock Bypass Frp Lock and also you can use this isp pinout for flashing.

Vivo Y17 Boot repair Emmc pinout: In This Tutorial Show You how to fix and boot repair EMMC and BOOT for Vivo Y17, you can find an Vivo Y17 test point and emmc pinout/isp for oppo mobile phone essay.Vivo Y17 isp pinout Ufi with easy jtag normal method you write repair file and worked dump and all ok but phone, not power on and not entered to download mode and after many try I find the solution for this model and i record this tutorial for Vivo Y17 isp pinout all steps to fix and repair this phone and I share all files used for repair.

This post related jtag team.if you dead boot repair any brand phone you need a two dongle best in market one is easy jtag plus and another is ufi box both are best in the market. those boxes help some phone after flashing wrong firmware not show booting on-screen.this you need those boxes for boot repair. some brands not possible lock remove like a pin, pattern, password ,frp and MDM lock this really supports for remove locks.

Here is the  Vivo Y17 can be used to overcome some software problems on Vivo Y17 phone, to direct it you can use a flasher box that has direct isp feature support and usually the flasher box can also be used for repairing emmc like Easy Jtag, Ufi, etc.

Read More:-  Oppo Reno3 ISP PinOUT | Remove FRP, Pattern Using Easy JTAG Plus

Vivo Y17 EMMC (ISP) Pinout

Okay, just follow this Direct eMMC Vivo Y17 Pinout, please download

Vivo Y17 EMMC Pinout For Remove User Lock And FRP

So that later when you want to direct again you are not confused looking for the Direct Pin, please boss just save it on HDD boss so that at any time there are cases that can be used again, congratulations, try the boss. one, please jumper for VCC VCCQ CLK CMD D0 GND for GND or ground don’t forget the jumpers are also bosses, otherwise, the jumpers don’t connect later.

Clear User Lock, you can try using the ISP method via UFI eMMC ToolBox, use “Factory Reset” under Special Task in User Partition Tab. Or using AETOOL by MRTkey (Android Emmc Tool)

Leave A Reply

Your email address will not be published.