Xiaomi Redmi Y2 Touch Ways | Repair Touch Screen Problem
If you are a mobile technician and searching for the Xiaomi Redmi Y2 Touch Screen Problem, Touch Ways, Touch Screen Jumper then you landed at the right place here we will show you the tested and working solution of Redmi Y2 Touch Screen Not Working Problem.
When the touch screen of your smartphone stops working, it can be a sign of a firmware issue or a hardware problem. That is the reason why you need to do some troubleshooting procedures to be able to know why it occurs.
We have already encountered similar issues in the past and there were cases wherein the touchscreen stops working after the device was dropped or got wet. But there were also cases where the problem occurred without any obvious reason.
As a mobile technician, you should be the first one to know what happened to the phone prior to the problem. And if you think that it happened due to physical or liquid damage, then there’s only so much you can do about it. But if it occurred due to some firmware or app issues, then you can make your phone respond again. Continue reading as we may be able to help you fix your Samsung Galaxy A10 with its touchscreen that stopped working for some reason.
Possible Causes of Xiaomi Redmi Y2 Touch Screen Problem
- Broken or damaged touch screen
- Rust from water damage
- Disconnection from the touch screen socket or connector
- A damaged or broken connecting path (open circuit)
- A faulty or missing resistor, capacitor, IC (integrated circuit) etc
- A bad firmware or operating system software files
Redmi Y2 Touch Screen Problem Solution – Touch Ways:
Here is the hardware solution of Redmi Y2 touch screen ways problem: Redmi Y2 Charging Ways Solution
Unplug and plug touch screen strip and check. Plug in any other good Touch Screen and Check.
This step is to verify whether the problem is in hardware or Xiaomi Redmi Y2 touch screen is faulty. If the problem is in hardware then clean the touch onboard connector and check.
Gently heat surrounding components of the touch screen and check. Re-solder each pin of the touch connector and check.
Please note that we will edit these solutions or add new ones if found on this page at any time in the future. So feel free to come back any time on this page to stay up to date.
Connect with us
We are always open to your problems, questions, and suggestions, so feel free to contact us by filling up this form. This is a free service we offer, and we won’t charge you a penny for it. But please note that we receive hundreds of emails every day, and it’s impossible for us to respond to every single one of them. But rest assured we read every message we receive. For those whom we’ve helped, please spread the word by sharing our posts to your friends or by simply liking our Facebook page.