Xiaomi 14 Ultra UFS ISP Pinout
If you are a mobile technician dealing with a Xiaomi 14 Ultra (aurora) that is pattern-locked, stuck on logo, or has a corrupted boot, the ISP (In-System Programming) method is probably the most reliable way to bypass these issues without removing the UFS chip.
Unlike standard USB flashing, the ISP method connects directly to the device’s UFS chip. This guide provides the tested pinout and the technical details you need to perform repairs with tools such as UFI Box, EasyJTAG Plus, or Flash64.
What is ISP pinout?
ISP in system programming allows us to have direct access to the eMMC/UFS memory with the device still soldered to the PCB (printed circuit board) using a proper box, such as Flash64 UFI, Easy-JTAG, or Medusa.
By using the ISP pinout, we can perform operations such as a full dump, firmware update, boot repair, FRP removal, and security backup without requiring a chip-off procedure. That way, we reduce our time, costs, and risks of damaging the PCB
Xiaomi 14 Ultra UFS ISP Image:
Remove the back panel carefully. The glue will be robust because the Xiaomi 14 Ultra has high IP ratings (IP68/69). Take care when using a heat gun and cutting tool. To view the UFS chip area, remove the motherboard shield.
RxoN (Receive Data Negative)
RxoP (Receive Data Positive)
Txon (Transmit Data Negative)
Txop (Transmit Data Positive)
Important Note: This current layout may require precision CPU scratching to access specific lines safely. We are continuously tracking new hardware solutions—as soon as a reliable “No CPU Scratch” ISP pinout method is found, this post will be updated immediately.
Tip: Use a microscope or a 10x magnifier to identify the points correctly. Don’t depend only on diagrams; confirm the layout visually.
Required Tools for ISP Pinout:
- Make sure your table is set up with the right tools before jumping in:
- UFI Box, Flash64, or EasyJtag
- 0.1mm – 0.3mm jumper wire
- Fine tip soldering iron
- Isopropyl Cleaner (IPA 99%)
- Soldering flux
- Multimeter (for checking continuity)
How to Connect Xiaomi 14 Ultra ISP to the Box
1. Hardware Preparation
- Safety: Remove the battery to prevent electrical shorts or voltage surges.
- Cleaning: Use isopropyl alcohol to clean the ISP points on the PCB.
- Soldering: Securely jumper wires to the Rst, Txop, Txon, Rxop, and Rxon points.
- Verification: Use a multimeter to check for shorts between lines or to ground.
2. Box Connection
- Connect the jumper wires to your UFI Box, EasyJTAG, or Flash64 adapter according to the tool’s specific pinout.
- Supply power to the board via the VCC/VCCQ pins or by connecting a USB cable to the device.
3. Software Configuration
- Open the eMMC/UFS tool software.
- Select Identify eMMC/UFS.
- If successful, the chip information (CID, User Area size) will populate the log.
- Navigate to User Partition > Special Task.
- Select Reset FRP or Factory Reset to complete the operation.
