Samsung Galaxy Tab A7 SM-T505 ISP PinOUT | Test Point
If you want to access the ISP Pinout connection of your Samsung Galaxy Tab A7, you can follow the step-by-step guide below. This will allow you to bypass the FRP lock and reset your user data using a tool such as the EasyJTAG Plus Box. For more detailed information, refer to the guide below.
Z3x Samsung Tool, Easy JTag, and UFI Box can bypass Samsung Galaxy Tab A7 SM-T505 Fingerprint, pattern, and screen locks. It doesn’t matter how much knowledge you have of Android software; this method will make the problem disappear quickly. If you see the message “USB not recognized,” your USB doesn’t work. You can only use this method if your battery is fully charged and your USB port works properly. Remember to leave your questions in the comments; I will do my best to answer them.
To communicate with the EMMC chip on the Samsung SM-T505, we need to locate the Test Point. The Test Point is a particular spot on the device’s PCB that allows us to establish a connection for ISP operations. To find the Test Point, we can carefully examine the device’s schematics and conduct thorough research. Once we have identified the Test Point, we can proceed with further exploration.
What is Samsung Galaxy Tab A7 SM-T505 ISP Pinout?
The ISP EMMC PinOUT, or In-System Programming EMMC PinOUT, is a configuration of specific pins on a device’s circuit board. This configuration provides direct access to the embedded multimedia card (EMMC) storage, which allows for read, write, and programming operations. If you are troubleshooting or repairing a Honor X6, understanding and locating its ISP EMMC PinOUT is crucial.
Samsung Galaxy Tab A7 SM-T505 ISP EMMC Pinout Image:
Hardware Process:
- The back case needs to be taken off of your phone. Next, disconnect the motherboard from the camera, fingerprint reader, and battery that are already there.
- Remove the motherboard’s screws, take it out, and store it somewhere safe.
- Find the six eMMC pins on your device. These are the pins: VCC, GND, Dat 0, CLK, and VCCQ. To get to them, you will have to cut through a steel cover.
- Get the adapter out of the UFI box. In the connector I talked about in the last step, you will see the same pins.
- There are four jumpers between the base and the adapter. You need to solder Dat0, CLK, CMD, and GND. I left the VCC and VCCQ on the USB so it could turn them off.
Two of the greatest dongles on the market, the easy jtag plus and the ufi box, are required to fix a dead boot on a Samsung Galaxy Tab A7 SM-T505, or any other brand of phone. When phones flash the wrong firmware, those boxes help them not show starting on the screen. For boot repair, you need those boxes. Some brands don’t let you remove locks like PIN, pattern, password, FRP, and MDM locks. This really allows you to remove locks.
How to Use UFS Pinout using Easy JTag
- Download the Latest Easy Jtag Setup From here
- Locate the PinOUT/Test Point on your device by looking at the image above.
- Make sure you follow the software guidelines. Alternatively, you can use the Z3X Samsung Tool Pro
Thank you for reading this guide on finding Samsung Galaxy Tab A7 SM-T505.
